Effect of Pressure and Hot Filament Cathode on Some Plasma Parameters of Hollow Anode Argon Glow Discharge Plasma
American Journal of Modern Physics
Volume 5, Issue 3, May 2016, Pages: 30-38
Received: Apr. 1, 2016;
Accepted: Apr. 25, 2016;
Published: May 23, 2016
Views 4683 Downloads 144
Sh. Kh. Al-Hakary, Department of Physics, Faculty of Sciences, University of Zakho, Duhok, Iraq
The present study represents a review article and a complementary study to a published paper of direct current hot cathode and hollow anode argon glow discharge plasma at different pressures in the range 0.05 - 0.8 mbar. The glow discharge usually obtained by applying a high voltage between the electrodes sufficient to occurring breakdown of argon gas and sustaining the discharge. Additional estimation of some plasma parameters, ion temperature, degree of ionization and electron energy distribution function as well as some characteristics of glow discharge under the influence of pressure and filament current has been done. Plasma parameters have been calculated using single probe method at fixed discharge current Id=1.88mA and diameter of hollow anode. Furthermore a computer MATLAB program is applied for this purpose. Results show that the average discharge voltage increases while its average discharge current decreases according to the increasing of the filament current. On the Contrary the average discharge voltage decrease nearly exponentially whiles its average discharge current increases according to increasing of the gas pressure. Degree of ionization starts to increase from low pressure to medium and then tends to decrease toward high pressure investigated. However it starts to increase to maximum value at filament current 0.9A then tends to decrease at higher current and low pressure. While for high pressures there is no significance change. Ion temperature increases slowly with filament current up to 0.9A and then sharply increases to maximum value at 1.5A. But it decreases for pressures in the range 0.05 - 0.09 mbar and then increases with gas pressure. Electron energy distribution function (EEDFs) decrease according to increases filament current, however, it starts to increase from low pressure to maximum value at medium pressure then tends to increase according to further increases of pressure.
Sh. Kh. Al-Hakary,
Effect of Pressure and Hot Filament Cathode on Some Plasma Parameters of Hollow Anode Argon Glow Discharge Plasma, American Journal of Modern Physics.
Vol. 5, No. 3,
2016, pp. 30-38.
M. Cercek, T. Gyergyek "Structure of discharge plasma with negative ions model and simulation" 31st EPS Conferences on Plasma Phys. London, 28 june-2 July, ECA Vol. 28G P-4.2282004.
N. Miyamoto, N. Hamamoto, S. Imakita, A. G. Mendenilla, and M. Wada "Development of a coaxial hot cathode for magnetized ion source plasma "AIP Conf. Proc. Vol. 1066, 304, 2008.
W. Handly and S. Robertson "A Hot- filament with very low electron temperature" Phys, Plasmas, Vol. 16, 010702, 2009.
E. Flaxer "Programmable smart electron emission controller for hot filament" Rev. Sci. Instrum. Vol. 82, 025111, 2011.
K. Yasserian, A. Fateh Borkhari and D. Dorranian "The breakdown characteristics in the presence of a hot filament for Ar and N2 gases" World Applied Science Journal 16 (6): 755-758, 2012.
I. V. Schweigrt, I. D. Kaganovich and V. I Demidov "Active electron energy distribution function control in direct current discharge using auxiliary electrodes" Physics of Plasma 20, 01606, and 2013.
M. Salahshoor, A. A. Zavarian, M. Salehi and S. M. J. Ghotbi "Constriction of a hot cathode plasma source for ion beam sputter deposition" Iranian Journal of Surface and Engineering, No. 17, PP. 31-35, 2014.
V. I. Arkhipenko, L. V. Simonchik "Effect of cathode heating and positive column contraction on the spatial distributions of parameters in cathode region" 32nd ICPIG, July, 2015, 26-31, Iasi, Romania.
W. L. Holtgreven "plasma diagnostic" Ed, Ch. 11. North Holland, Amsterdam, Holland, 1968.
K. Al-Hakary, Luqman, Doskyand, Shamil K. Talal "Investigation of cathode and hollow anode of argon glow discharge plasma" Applied physics research. Vol. 6, No. 5, 2014.
B. Jomachi and B. Klobes "Franck-Hertz experiment" Advanced Laboratory Course, University Bonn, 2005.
Grill "Cold plasma in materials fabrication from fundamentals to applications" Institute of Electrical and Electronic Engineers, Inc, New York, USA, 1993.
M. Swarnalatha, C. Sravani, K. R. Gunasekhar, G. K. Muralidhar and S. Mohan "Estimation of density of charge species in a triode discharge system "Vacuum, Vol. 48, No. 10, 845-848, 1997.
Esho Q Yuokhana, Luqman M. S. Dosky, Shamoo K Al-Hakary "Plasma parameters in hot cathode glow discharge" J. Duhok. University, Vol. 13, No. 1 (Pure and Eng, Science), Pp. 184-190, 2010.
L. Merlio "Understanding Langmuir probe current –voltage characteristics" Am. J. Phys, Vol. 75, No. 12, 2007.
Bijal Vara, C S Dalal, S Karkari, H Kabariya "Langmuir probe diagnostic for local parameter measurement in magnetized plasma using Lab VIEW" Bijal Vara et al Int. Journal of Engineering Research and Applications www.ijera.com ISSN: 2248-9622, Vol. 4, Issue 3 (Version1), March, 2014, pp. 244-247.
Tsanko Tsankov, Zhivko kiss, Ovski, Nina, Djermanova, Stanimir, Kolev "Electron energy distribution function in an inductively driven tandem plasma source" Plasma processes and polymers, DoI: 10.1002/ppap.200200092, 2005.
Annette Meiners "Electron energy distribution function" CONSOL conferences, 2014.